DeLonghi HSX4315ECA Mode D'emploi page 14

comfort while reducing energy consumption.
NOTE: While the "ECO plus" function is active, the appliance
may switch automatically to a lower heating power than the
one displayed.
Working indicator
The symbol indicates the heating status by means of its
colors.
RED: the unit is heating at the maximum power.
YELLOW: the unit is heating at the medium power.
GREEN: the unit is heating at the minimum power.
absent: the unit is not heating.
Brightness of the display
The appliance allows two different brightness settings for
the display. The display is brightest when any key button
is pressed. After a few seconds of keyboard inactivity, the
brightness will decrease to the operating brightness level.
Key lock
In order to avoid accidental operation, you can lock the
keyboard using the keylock function. To activate this function
press buttons + and - (C) together for at least 3 seconds. The
display shows the symbol
emitted. To deactivate the function, repeat the same steps
and the keylock symbol will disappear.
Timer function
This function can be activated in two different ways.
Delayed start: With the appliance OFF press the timer
button (F) . The
together with the hours left before the appliance comes on.
Change the hours using the + and - (C) buttons, then wait
a few seconds for the program to be stored. The display will
return to off and the
programmed time has elapsed, the appliance will come on
with the previous settings.
Delayed stop: with the appliance ON, press the timer button
(F). The symbol is displayed flashing together with
the hours left before the appliance goes to standby. Change
the hours using the + and - (C) buttons, then wait a few
seconds for the program to be stored. The current settings
and symbol are displayed.
At the end of the set time, the appliance switches to standby
and an acoustic signal will be
symbol is displayed flashing
symbols remains on. When the
automatically. To go back to operating without the timer,
press the timer button twice.
The timer symbol
Please note: the time is settable from 0.5 to 24 hours.
Changing of the temperature scale
The display can show the temperature in both °F (Fahrenheit)
and °C (Celsius). To select the desired temperature scale,
when the unit is in standby position, press and hold the "+"
key for at least 10 seconds, then release.
The change of scale will be indicated by two short beeps.
SAFETY FUNCTIONS
Safety device: The appliance is fitted with a safety
-
cutoff device which will switch the appliance off in case
of accidental overheating. To reset the cutoff, disconnect
the plug from the power supply for a few minutes,
remove the cause of overheating, then reconnect the
appliance. If this abnormal situation happens several
times, contact customer service.
- Tipover safety device: This device turns the appliance
off if it falls over or is positioned inappropriately in such
a way as to jeopardize safety. The appliance emits a
beep and a dot flashes on the display. Few seconds
after being placed in upright position the appliance will
switch to STAND-BY.
Alarms
The appliance has a diagnostic system that makes it possible
to signal malfunctions.
In case of problems, the display will show an alarm message:
(Probe failure) and
troubleshooting section.
MAINTENANCE
Before carrying out any maintenance, unplug the heater
from the outlet and wait for it to cool off completely.
This heater requires no particular maintenance. It is
sufficient to remove the dust with a soft, dry cloth.
Never use abrasive powders or solvents. If necessary
remove concentrated areas of dirt with a vacuum cleaner.
WARNING: any other servicing should be performed by an
authorized representative.
Should the heater not be in use over a certain length of time,
roll the cable around the feet and store it in a dry place.
14
disappears from the display.
(High temperature), see