DeLonghi HSX4315ECA Mode D'emploi page 11

Do not use the appliance in areas where
gasoline, paints, or other flammable
liquids are used or stored.
- Use this heater only as described
in this manual. Any other use not
recommended by the manufacturer
may cause fire, electric shock, or injury
to persons.
- To prevent overload and blown fuses, be
sure that no other appliance is plugged
into the same outlet (receptacle) or into
another outlet (receptacle) wired into
the same circuit.
- Make sure that the plug is fully inserted
into the outlet. Wall outlets may
deteriorate with time, so check the plug
periodically for signs of overheating
or deformation. If the outlet has
deteriorated, stop using it and have it
repaired.
- Do not use the appliance in small rooms
when they are occupied by persons that
are not capable of leaving the room,
unless constant supervision is provided.
Danger of burns!!
Failure to observe the warning could result in burns or scalds.
- WARNING:
overheating, never under
any circumstances cover the
appliance during operation as this
would lead to a dangerous rise in
temperature, and risk of fire.
- Do not use the appliance on soft
surfaces, such as beds, where the
openings may become blocked.
- This heater is hot when in use. To
prevent burns, do not let bare skin
touch hot surfaces. Use handle when
moving this heater. To prevent burns,
ydo not touch hot surfaces with bare
To avoid
skin. Use the handle when moving
the appliance. Keep all flammable
materials, such as furniture, pillows,
bedding, paper, clothing, and curtains
at least 3 feet (90 cm) from the front
and top of the appliance and avoid
contact with the sides and back (fig. 3).
- Do not run cord under carpeting. Do not
cover cord with throw rugs, runners, or
the like. Arrange cord away from traffic
area and where it will not be tripped
over.
- It is normal for the heater's plug and
cord to feel warm to the touch. A plug
or cord which becomes hot tothe touch
or becomes distorted in shape may
be a result of a worn electrical outlet.
Worn outlets or receptacles should
be replaced prior to further use of
the heater. Plugging heater into a
worn outlet /receptacle/ may result in
overheating of the power cord or fire.
- WARNING: Do not cover the appliance
while it is functioning in order to avoid
overheating which may cause risk of
fire.
Symbol meaning
This simbol indicates:
Class II equipment (If provided)
Please note:
This symbol indicates recommendations and important
information for the user.
- If your appliance is equipped with a
polythene tape used as carry handle,
remove it before connecting appliance
to the outlet.
- Always use the appliance in an upright
position.
- To disconnect heater, turn controls to
off, then remove plug from outlet.
11