Orbegozo SF 1045 Manuel D'instructions page 10

SF 0345
• DO NOT USE fan in window. Rain may create an
electrical hazard. Do not leave the fan operating
adjacent to an area where water has been collected to
avoid the potential of electrical hazard.
ASSEMBLY INSTRUCTIONS
Assembly of stand:
1. Unscrew the nut of telescopic tuve and pull up inner tuve until desired height.
2. Tighten the nut of telescopic tube to fix position.
3. Place telescopic tube in the base and screw on bottom side of base The stand will be ready for using.
Assembly of blade and grill
1. Remove the nut from motor shaft.
2. Place rear grill in motor shaft and fit it with the nut.
3. Place the blade in motor shaft and before fit it with nut as above picture shows.
4. Put the outer ring on front grill and join it with rear grill.
5. Fix the grills tightening the screw of outer ring.
6. Put the head of fan into the telescopic tube and tighten the screw of head to fix it.
10