Publicité
Les langues disponibles
Les langues disponibles
Battery capacity - end of operational readiness
• The battery level indicator notifies
you that the machine is ready for op-
eration.
• Blinking red LED:
2 minutes to finish working before the machine automati
cally switches off.
• Solid red LED:
Requires a full charging cycle.
Cleaning method
Direct working method:
Scrubbing and suction in one work step.
Indirect working method:
Applying the cleaning solution, scrubbing and suction in sev-
eral work steps.
Notice:
The machine guiding might be impaired in
case of special combinations of flooring/
contamination and cleaning product.
Optionally available wheels can improve
the traction of the machine on the floor.
Please contact your TASKI customer con-
sultant.
Replenishing cleaning solvent
Attention:
The flooring may be damaged when work-
ing without cleaning solution.
Notice:
A rattling sound of the pump indicates that
the fresh water tank is empty.
Attention:
The pump must never run dry for an ex-
tended period.
• The machine must be switched off.
• Open the tank lid.
• Fill the fresh water tank with water, see page 68.
• Add the cleaning product using the dosing cup.
• Close the tank lid.
Draining dirty water
• If the recovery tank is full, the floater
will be sucked onto the suction filter.
This will be indicated by a change of
the noise by increasing the suction
speed as well as residual water at the
bottom.
• Drain the recovery tank, see page 71.
70
End of operation
• Drive on for a few meters so that the brushes keep on ro-
tating for a short time to avoid dripping.
-
Very important for TASKI contact pads!
• Drive on for a few meters in order to absorb the remaining
drain water.
• Switch off the machine.
Attention:
The machine must now be emptied and
cleaned. Switch off the machine (main
switch) and disconnect the battery discon-
nection socket before beginning with the
following steps.
• Press the Brush drive ON/OFF but-
ton.
The cleaning solution supply is
stopped.
• To lift the tool, push the foot pedal
downwards until it engages.
• Lift the squeegee.
Allow the suction unit to run on so
that the remaining waste water in the
hose is sucked up.
• Press the Suction unit ON/OFF but-
ton.
The display lights up; the suction en
gine stops.
-
Publicité
