DeWalt DW004 Serie Mode D'emploi page 29

Hammer drilling:
for concrete and masonry drilling
• Select the required operating mode by rotating
the mode selector (3) towards the symbol on the
gear housing.
• For screwdriving, refer to section «Instructions for
use».
DW005 - Selecting the operating mode (fig. C)
This tool can be used in three operating modes:
Rotary drilling:
for screwdriving and for drilling into steel,
wood and plastics
Hammer drilling:
for concrete and masonry drilling
Hammering only with spindle lock:
for light chipping, chiselling and
demolition applications
• Select the required operating mode by rotating
the mode selector (3) towards the symbol on the
gear housing.
• For screwdriving, refer to section «Instructions for
use».
Inserting and removing SDS-plus accessories
(fig. D)
Your rotary hammer drill uses SDS-plus accessories
(refer to the inset in fig. C for a cross-section of an
SDS-plus bit shank).
• Clean and grease the bit shank.
• Insert the bit shank into the tool holder (7).
• Push the bit down and turn it slightly until it fits
into the slots.
• Pull on the bit to check if it is properly locked.
The hammering function requires the bit to be
able to move axially several centimetres when
locked in the tool holder.
• To remove a bit pull back the tool holder locking
sleeve (13) and pull out the bit.
Fitting the side handle (fig. E)
The side handle (4) can be fitted to suit both
RH- and LH-users.
Always use the tool with the side handle
properly assembled.
• Loosen the side handle.
• For RH-users, slide the side handle clamp over the
collar behind the tool holder, handle at the left.
• For LH-users, slide the side handle clamp over
the collar behind the tool holder, handle at the
right.
• Rotate the side handle to the desired position
and tighten the handle.
Setting the drilling depth (fig. F)
• Insert the required drill bit.
• Slacken the side handle (4).
• Fit the depth adjustment rod (5) through the hole
in the side handle clamp.
• Adjust the drilling depth as shown.
• Tighten the side handle.
Forward/reverse slider (fig. G)
• Push the forward/reverse slider (2) to the LH-side
for forward (RH) rotation.
• Push the forward/reverse slider (2) to the RH-side
for reverse (LH) rotation.
• Move the forward/reverse slider (2) to the central
position to lock the switch when changing
accessories, inserting the battery pack or when
storing or transporting the tool.
Always wait until the motor has come to
a complete standstill before changing the
direction of rotation.
Replacing the dust cover (fig. D)
The dust cover (6) prevents dust ingress into the
mechanism. Replace a worn dust cover
immediately.
• Pull back the tool holder locking sleeve (13) and
pull the dust cover (6) off.
• Fit the new dust cover.
• Release the tool holder locking sleeve.
Instructions for use
• Always observe the safety instructions
and applicable regulations.
• Be aware of the location of pipework and
wiring.
E N G L I S H
29