Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
LOCATE AND MOUNT REMOTE SENSOR
Before drilling holes for mounting the Remote Sensor, verify the area(s) chosen for mounting allows good wireless
communication to the Equipment Control Module. Place the remote(s) where they will be mounted (but do not drill holes yet)
ƒ† ˆ‘ŽŽ‘™ •–‡’• ‹ ’‘™‡”‹‰ ”‡‘–‡ ˆ –Š‡ ”‡‘–‡ •‡•‘”• ƒ”‡ ‘—– ‘ˆ ”ƒ‰‡ •–ƒ–—•
location may be required.
Indoor Remote Sensor
Locate Wireless Remote Sensor(s) 5' ‘ –Š‡ ‰”‘—† ‹ ƒ ƒ”‡ƒ –Šƒ–
”‡’”‡•‡–• –Š‡ „‡•– Ž‘…ƒ–‹‘ –‘ ƒ˜‡”ƒ‰‡ –Š‡ –‡’‡”ƒ–—”‡ „‡–™‡‡
Comfort Interface and Remote Sensor location.
‡‘˜‡ …‘˜‡” „› Š‘Ž†‹‰ ‡‘–‡ ‡•‘” „ƒ•‡ ƒ† ’”‡••‹‰ –Š‡
–ƒ„ ƒ– –Š‡ „‘––‘ –‘™ƒ”† –Š‡ –‘’ ‘–‹—‡ –‘ •Ž‹†‡ …‘˜‡” —’ –‘
”‡‘˜‡ ˆ”‘ „ƒ•‡
Use base to mark mounting hole location on wall. Drill mounting
holes. Remote sensor can be attached to wall after checking operation.
For indoor use, the bracket is optional.
Outdoor Remote Sensor
If the sensor is going to be used outdoors, clip the indoor/outdoor
jumper labelled W1.
Locate wireless remote sensor setup out of direct sunlight. Direct
•— ‡š’‘•—”‡ ™‹ŽŽ ƒ ‡…– •‡•‡† –‡’‡”ƒ–—”‡
Make sure it is mounted in upright position and in a dry location
—†‡” ƒ …‘˜‡”‡† ƒ”‡ƒ Ž‹‡ ƒ „ƒ› ™‹†‘™ ‘” ”‘‘ˆ ‘˜‡”Šƒ‰
NOTE
D
‘—–‹‰ „”ƒ…‡– ‹• ’”‘˜‹†‡† –‘ ‡‡’ –Š‡ ‘—–†‘‘” •‡•‘” ƒ™ƒ›
from the mounting surface and away from water buildup.
Install mounting bracket to wall at desired location. Outdoor
Remote Sensor can be attached to mounting bracket after
checking wireless operation.
POWERING THE REMOTE/CONNECTING TO 1F98 1621
1. •–ƒŽŽ „ƒ––‡”‹‡• –‘ ’‘™‡” ”‡‘–‡
2. Go to Equipment Control and press the Connect button.
Equipment Control Status LED will blink green indicating
•‡ƒ”…Š‹‰ ˆ‘” ™‹”‡Ž‡•• †‡˜‹…‡•
3. Press and hold the Connect button located on the inside of
–Š‡ ”‡‘–‡ •‡•‘” —–‹Ž
„—––‘
– –Š‡ ‡† ‘ˆ –Š‡ ƒ•Š •‡“—‡…‡ –Š‡
amber indicating the sensor number assigned.
1 ƒ„‡” ƒ•Š •‡•‘” 1
2 ƒ„‡” ƒ•Š‡• •‡•‘” 2
3 ƒ„‡” ƒ•Š‡• •‡•‘” 3
4 ƒ„‡” ƒ•Š‡• ‘—–†‘‘” •‡•‘” 4
2
IMPORTANT
™‹ŽŽ ƒ•Š ”‡† ƒ† ‰‘ ‘
•–ƒ”–• ƒ•Š‹‰ ‰”‡‡ –Š‡ ”‡Ž‡ƒ•‡
™‹ŽŽ •™‹–…Š –‘
‘ •‡•‘” ™‹ŽŽ ƒ•Š ”‡† •‘ ƒ †‹ ‡”‡–
Ž‹†‡ …‘˜‡”
‘ ‘ˆ „ƒ•‡
2 "AA" batteries
Clip W1 for
outdoor use
Press Connect
button
LED On/Off
W/E
W2
Y
Y2
G
O/B
L
R
R
RC
RC
RH
C
C
HM
HM2
DHM
Connect
DHM2
Equipment Control Module
‘˜‡”
Base
Mounting
Holes
Up
Mounting
holes
Bracket
mounting
holes
Press Connect
button
Remote Sensor
Publicité
Table des Matières
