Lipo Battery Charging; Ready To Start - Carson X4 Quadcopter Nano Spy Manuel D'instructions

LIpo battery cHargIng

the quadcopter is fitted with a LiPo battery.
3.7 V LiPo battery.
1. The supplied LiPo battery is stored in the body of the quad-
copter.
2. Connect the quadcopter to the connector of the USB charger.
The indicator on the USB plug lights up and goes out again once
the charging process is complete.
Do not leave the copter or the charger unattended during the
charging process and always disconnect the battery from the
charger after completion! While charging, place the battery and
charger on a fireproof base!

reaDy to Start

Now we're good to go! But before liftoff, make sure that you have read this manual through completely.
1
Switch on the transmitter. Move the left-hand joystick all the way
downwards (illustration).
3
Now move the throttle lever completely up and then all the way
back down. Now the quadcopter is ready to launch.
GB // 24
ON/OFF
2
Switch on the quadcopter and place it on a flat surface.
ON/OFF
switch