Adjust The Tilt Stand; Connect The Ir-Usb Cable - Keysight Technologies U1273A Guide De L'utilisateur

1 Introduction

Adjust the tilt stand

To adjust the multimeter to a 60° standing position, pull the tilt-stand outward to
its maximum reach.
Figure 1-5

Connect the IR-USB cable

You can use the IR communication link (IR communication port, located at the
rear panel) and the Keysight GUI Data Logger software to control your multimeter
remotely, perform data logging operations, and transfer the contents of your
multimeter's memory to a PC.
Ensure that the Keysight logo on the U1173A IR-USB cable (purchased
separately) connected to the multimeter is facing up. Firmly push the IR head into
the multimeter's IR communication port until it snaps into place (see
Refer to the Keysight GUI Data Logger Software Help and Quick Start Guide for
more information on the IR communication link and the Keysight GUI Data Logger
software.
30
Pull until maximum reach
Tilt-stand adjustment and IR-USB cable connection
To PC (host)
IR-USB cable
Keysight U1273A/U1273AX User's Guide
Figure 1-5).