Keysight Technologies U1273A Guide De L'utilisateur page 23

Preparing Your Multimeter
Check the shipment
When you receive your multimeter, check the shipment according to the following
procedure.
1 Inspect the shipping container for damage. Signs of damage may include a
2 Carefully remove the contents from the shipping container, and verify that the
3 For any question or problems, refer to the Keysight contact numbers on the
Install the batteries
Your multimeter is powered by four 1.5 V AAA batteries (included with the
shipment). When you receive your multimeter, the AAA batteries are not installed.
Use the following procedure to install the batteries.
Before you proceed with the batteries installation, remove all cable
CAUTION
connections to the terminals and ensure that the rotary switch is at the
OFF position. Use only the battery type specified in the datasheet at
http://literature.cdn.keysight.com/litweb/pdf.
Keysight U1273A/U1273AX User's Guide
dented or torn shipping container or cushioning material that indicates signs
of unusual stress or compacting. Save the packaging material in case the
multimeter needs to be returned.
standard accessories and your ordered options are included in the shipment
according to the standard shipped items as below:
– Standard test leads
– Test probes with 4 mm tips
– K-type thermocouple and adapter
–
4 x 1.5 V AAA alkaline batteries (for U1273A) or lithium batteries (for U1273AX)
– Certificate of Calibration
back of this manual.
Introduction 1
23