Klarstein 10009872 Instructions D'utilisation page 15

Fault
There is a little juice.
The cutter holder is seized.
Notes: The table above introduces the common faults and their cause analysis and elimination methods.
For other faults, contact our customer service department or have the product repaired by a designated
service center of us directly. Do not dismantle or repair the product by yourself.
Hints on Disposal
According to the European waste regulation 2002/96/EG this symbol on the product or
on its packaging indicates that this product may not be treated as household waste.
Instead it should be taken to the appropriate collection point for the recycling of electri-
cal and electronic equipment. By ensuring this product is disposed of correctly, you will
help prevent potential negative consequences for the environment and human health,
which could otherwise be caused by inappropriate waste handling of this product. For
more detailled information about recycling of this product, please contact your local
council or your household waste disposial service.
Declaration of Conformity
Producer: Chal-Tec GmbH, Wallstraße 16, 10179 Berlin, Germany.
This product is conform to the following European Directives:
2014/30/EU (EMC)
2014/35/EU (LVD)
2011/65/EU (RoHS)
15
Possible cause
There are too many residues in
the middle ring; or The pushing
rod is pushed violently.
The cutter holder is wound or
seized by food materials.
Elimination
Clean the middle ring; or
Gently push the pushing rod.
Disconnect the power supply,
take out the food materials and
cut them into smaller blocks.