Klarstein 10009872 Instructions D'utilisation page 12

Put the fruit residue cup below the fruit residue outlet of the
4 Snap bottom of the fruit residue cup into the corresponding
Connect the power supply and prepare for run.
Make the operating time equal to or smaller than 1 minute
5
(make sure the switch is off before connecting
Clean fruits and vegetables and cut them into blocks suitable
6
(remove hard seeds or shells or thick skins of the fruits
Take a juice cup and place it below the juice outlet (the product is not
provided with a juice cup. You can choose one by yourself. It is
suggested to choose one with a height similar to that of the juice nozzle
7 of the product to avoid juice splashing). Start the switch and select a
gear according to type of the fruit processed (see "Tips for fruit selec-
tion"). It is suggested to make the continual operating time not longer
than 1 minute for a longer life of the product.
Put the cut fruit blocks into the feed opening of the top cover and
push them gently with the pushing rod. For a good juicing effect,
If the fruit residue outlet is blocked or the fruit residue cup
8
or the juice cup is full after the product has run for some
time, disconnect the power supply and clear up the fruit
residue outlet before starting the product again.
Never put fingers or other articles into the feed opening.
When there is no longer juice flowing via the juice outlet after good
material processing, make the switch off, disconnect the power supply
and take the juice cup from the juice nozzle after the motor and the
9
juice strainer have both stopped running
(drink the juice at one, otherwise its taste and nutrition will be
both influenced after some time of exposure in air).
middle ring in an inclined way.
position of the main unit.
the power supply).
for the food material inlet
and vegetables, if any, first).
do not push violently.
12