Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
4. Drilling mode selector
5. Chuck
Assembly
Warning! Before assembly, make sure that the
tool is switched off and unplugged.
Fitting the side handle and depth stop (fig. B)
(Only for HD5513V,HD5513KA40,HD5513KHA)
•
Turn the grip counterclockwise until you can slide the
side handle (7) onto the front of the tool as shown.
•
Rotate the side handle into the desired position.
•
Insert the depth stop (6) into the mounting hole as
shown.
•
Set the drilling depth as described below.
•
Tighten the side handle by turning the grip clockwise.
Fitting a drill bit or screwdriver bit
Keyed chuck (fig. C)
•
Open the chuck by turning the sleeve (9)
counterclockwise.
•
Insert the bit shaft (8) into the chuck.
•
Insert the chuck key (10) into each hole (11) in the side
of the chuck and turn clockwise until tight.
Removing and refitting the chuck (fig. D)
•
Open the chuck as far as possible.
•
Remove the chuck retaining screw, located in the chuck,
by turning it clockwise using a screwdriver.
•
Tighten an Allen key into the chuck and strike it with a
hammer as shown.
•
Remove the Allen key.
•
Remove the chuck by turning it counterclockwise.
•
To refit the chuck, screw it onto the spindle and secure it
with the chuck retaining screw
Use
Warning! Let the tool work at its own pace. Do not
overload.
Warning! Before drilling into walls, floors or ceilings,
check for the location of wiring and pipes.
Selecting the direction of rotation (fig. E)
For drilling and for tightening screws, use forward (clockwise)
rotation. For loosening screws or removing a jammed drill bit,
use reverse (counterclockwise) rotation.
•
To select forward rotation, push the forward/reverse slider
(3) to the centre position.
•
To select reverse rotation, push the forward/reverse slider
to the left.
Warning! Never change the direction of rotation while the
motor is running.
Selecting the drilling mode
•
For drilling in masonry, set the drilling mode selector (3)
to the
position.
•
For drilling in other materials and for screwdriving, set the
drilling mode selector to the
Setting the drilling depth (fig. F)
(Only for HD5513V, HD5513KA40, HD5513KHA)
•
Slacken the side handle (7) by turning the grip
counterclockwise.
•
Set the depth stop (6) to the desired position. The
maximum drilling depth is equal to the distance between
the tip of the drill bit and the front end of the depth stop.
•
Tighten the side handle by turning the grip clockwise.
Switching on and off
•
To switch the tool on, press the speed switch (1). For
tools with variable speed switch, the tool speed depends
on how far you press the switch. As a general rule, use
low speeds for large diameter drill bits and high speeds
for smaller diameter drill bits. ( HD5010VA5, HD5513V,
HD5513KA40,HD5513KHA )
ENGLISH
position.
5
Publicité
Table des Matières
