Kohler 31110-58 Guide D'installation page 10

5. Install the Shower Unit
CAUTION: Risk of personal injury. If the shower unit is
not securely held in place during installation, the product
may fall causing personal injury.
Thread a leveling nut onto each stud on the bracket.
Install the shower unit to the bracket. Each leveling nut should
stick through the shower unit. The copper inlet pipe should stick
through the water inlet gasket. Loosely install four sealing
washers (metal side down) and nuts on the leveling nuts.
Place a level across the shower unit and level by adjusting the
leveling nuts.
Hold the leveling nuts and tighten the nuts.
Ensure the foam gasket is compressed between the shower unit
and the ceiling. Fill any gaps with 100% silicone sealant.
1386786-2-A
Leveling
Nut
Sealing
Washer
10
Stud
Nut
Kohler Co.