Kohler 32517 Guide D'installation

Installation Guide
PREPARATION
1. Record your model number for future reference.
2. DANGER: Risk of electric shock. To avoid electric shock, the power must be turned off at the circuit breaker or fuse box before
beginning the installation procedure.
3. DANGER: Risk of electric shock. To avoid electric shock, the outlet box must be properly grounded.
4. Important Information. Inspect the product for any damages. This product is for indoor use only. Observe all local codes.
TOOLS AND MATERIALS NEEDED
Phillips &
Flathead Screwdriver
FIXTURE INSTALLATION
1. Remove the fixture and parts bag(s) from the carton. Put them onto
a clean and soft cloth to protect the finish. Confirm all parts are
included.
2. Loosen screws (F), remove mounting plate (B) from canopy (G).
3. Attach mounting plate (B) onto outlet box with screws (D). Ensure
ground screw (C) is attached to mounting plate.
4. Lift fixture and lace safety cord (J) around mounting plate (B), then
secure set screw (K) with Allen wrench.
5. NOTICE: To avoid short circuit, make sure wires are not exposed.
Fasten fixture green or bare ground wire to the green or bare copper
wire in outlet box with wire nut (A) or fasten onto ground screw (C)
on mounting plate.
6. NOTICE: To avoid short circuit, make sure wires are not exposed.
Fasten fixture white wire to the white wire in outlet box with wire
nut (A). Wrap the wire connector with electrical tape so that the tape
seals the end of wire nut (A). See diagram 1.
7. NOTICE: To avoid short circuit, make sure wires are not exposed.
Fasten the fixture black wire to the black wire in outlet box with wire
nut (A). Wrap the wire connector with electrical tape so that the tape
seals the end of wire nut (A). See diagram 1.
8. Insert Quick Connector (E) into the opposing quick connector end.
9. Tuck wires carefully inside outlet box. Attach canopy (G) onto
mounting bar (B) with screws (F).
10. NOTICE: Do not exceed recommended wattage. Rated Max 40W, 2-
pin G9 base bulb. (Bulb(s) not included).
11. Install bulb onto the socket.
12. Attach glass shade (I) onto socket sleeve (H) by turning it until the
connection is secure. Do not over tighten.
13. Repeat step 10-12 for all glass shades.
14. Restore power to circuit at breaker or fuse box.
CLEANING:
Please clean fixture with a soft and dry cloth ONLY. Clean
glass with a mild soap.
USA/Canada: 1-800-4 KOHLER
www.kohler.com
Please see next page for a larger installation image
Wire
Electrical Current
Cutter/stripper
Electrical
Tape
Tester
SKU#32517
Allen
Wrench
Electrical tape
Approved fastener
(Wire nut)
Diagram 1
1486926-2_B