Table des Matières
Publicité
FIAMMASTORE
EN
Read the following instructions and warnings carefully; failure to observe these installation and usage
instructions as well as the laws for driving in the relevant country may cause severe harm or damage
for which the manufacturer declines all responsibility.
Keep the original packaging to be used in case of return
Before installation, ensure compatibility with the vehicle on which the product must be installed.
Checking that the wall/roof is suffi ciently solid and suitable for guaranteeing the resistance of the
anchoring points is always mandatory. If not, grip and compliance with the maximum load indicated in
the instructions are not guaranteed and it will be necessary to reinforce it.
Before leaving, make sure the awning is correctly closed. A damaged fabric does not allow the
awning to perfectly roll in. Never use the awning with a damaged canopy.
Periodically check the fi xing status of the brackets, especially after having traveled the fi rst Kms from
the assembly and every time before and after long journeys, making sure that they have not moved
and that the tightening is correct.
Always comply with speed limits and the Highway Code. The speed should always be suitable to
traffi c conditions and towed load.
The awnings are produced with a high quality standard, but some of the characteristics of the
materials (as little imperfections on paint or linearity of aluminium profi les; little marks or light
deformations of plastic parts), which could be interpreted as defects, derive from the materials
and from the specifi c work processes, and these characteristics occur even though Fiamma uses
advanced and innovative machine production techniques.
Apart from our strict quality controls, we also have our fabrics continuously controlled by independent
institutes to ensure that the fabric is tear resistant, they can hold the weight of water, the colours don't
fade and it is resistant against atmospheric agents.
To guarantee a perfect quality, the fabrics are waxed or laminated several times.
During this operation, single coloured pigments could move and thus create small bright spots in the
material, which are only irregularities that are technically inevitable to avoid, but do not compromise
the impermeability of the fabric.
MAINTENANCE INSTRUCTIONS
Make sure that your awning is completely dry and clean before closing it.
The remaining humidity could cause stains. If however you have no choice but closing the awning
when it is still wet, make sure to open it for drying within 12 hours maximum. Most of the dirt is
superfi cial and can be removed with clean water and a cloth or a brush. If the fabric is very dirty, add
some light cleaning detergent (Marseille soap).
Be aware never to use any aggressive chemical substances and never to clean the fabric with a high
pressure machine. We recommend not to use the awning at a temperature below 0°C.
You are advised not to wash the outer covering of the awning with an aggressive product that could
alter the surface fi nishes or the materials.
If the awning is more than 100 mm out of the vehicle shape, the presence of the awning must be
recorded in the vehicle's registration documents
.
(DIN 75303 - 2019)
46
Publicité
Table des Matières
