Yamaha Soavo-900M Mode D'emploi page 4

ATTACHING THE FRONT COVER
The speaker and the front cover are packed separately. To
attach the front cover, line up the four salients (magnet) on
the reverse side of the front cover with the four
corresponding pegs.
Notes
• When the cover is not attached, take care not to
touch the speaker units with your hands or to exert
excessive force with tools.
• There are magnets on the reverse side of the front
cover. Do not place the front cover close to objects
that might be affected by magnets, such as TVs,
clocks, magnetic cards, diskettes etc. when you don't
use it.
4
En
SPECIFICATIONS
Type ............................. 2-way bass reflex speaker system
Driver ............................................ 13 cm (5") cone woofer
3 cm (1") aluminum dome tweeter
Impedance ................................................................... 6 Ω
Frequency Response ................ 56 Hz to 50 kHz (– 10 dB)
Nominal Input Power .................................................. 30 W
Maximum Input Power ............................................. 120 W
Sensitivity .................................................. 87 dB/2.83 V/m
Crossover Frequency ................................................ 3 kHz
Dimensions (W x H x D) ..................... 220 x 349 x 237 mm
Weight ..................................................... 6.0 kg (13.4 lbs.)
• Specifications are subject to change without notice due
to product improvements.
• Care should be taken not to exceed the input power
values noted above.
Taking care of the speaker
When you wipe this unit, do not use chemical solvents
(ex. alcohol or thinners etc.); this might damage the
finish. Use a clean, dry cloth. For heavy dirt, dampen a
soft cloth in detergent diluted with the water, wring it out,
and then clean this unit up with a soft cloth.
Magnetic shielding type
to 100 kHz (– 30 dB)
(8-11/16" x 13-3/4" x 9-5/16")