Publicité
Les langues disponibles
Les langues disponibles
4 BUTTONS REMOTE
NOTE: The unit Main Power Switch must be turn on
in order for the Remote Control to function.
POWER
The Power button will put the insert in a standby mode.
This will turn off all functions at once but will hold the
settings in memory. By pressing the button again the unit
will turn on at the same settings.
FLAME
Each time this button is pressed, the intensity of the
flame decreases. There are six brightness levels you
can cycle through including the OFF setting.
HEAT
This button will turn the power to the heater and
blower on and off. when the heater is turned ON it
will take several seconds for the unit to begin blowing
hot air. The rotary switch (Temperature) controls the
thermostat feature to help regulate your room's
temperature accordingly.
PLAY/PAUSE
Note:
This button function just apply for ARU series
model.
Press this button you can control the undulating flame
effect to play or pause.
NOTE: This equipment has been tested and found to comply with the limits for Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
Modifications not approved by the party responsible for compliance could void user's authority to operate the equipment.
This Class B digital apparatus complies with Canadian ICES-003.
REMOTE CONTROL FUNCTIONS
E-6
Fig. 4
Note: Please operate remote transmitter at a slow measured
pace. Depress the remote control buttons with an even motion
and gentle pressure. Repeatedly pressing buttons in rapid
succesion may cause the transmitter to malfunction.
Publicité
