Montipower DIE BLASTER Mode D'emploi page 21

®
Die Blaster
Correct
direction of operation
If the tool does not work correctly, check the following:
Æ Are you using a suitable belt for the surface to be machined? – Use the most suitable belt.
Æ Is the tool operating at the stipulated speed? – Problems with the tool, see section 9, Troubleshooting.
Æ Are you using an belt with the wrong direction of travel? – Fit the brush belt such that is runs in the correct
direction (see section 6, Placing in operation, Fig. 2).
Æ Is the accelerator bar showing signs of wear? Check accelerator bar. In case of wear, rotate by approx. 45°
or renew.
Less pressure = longer service life and
Holding machine
Operating instructions
higher performance
ENG
21