Compressed Air Supply - Montipower DIE BLASTER Mode D'emploi

®
Die Blaster Operating instructions ENG
5.

Compressed air supply

This compressed air tool is designed for a maximum flow pressure of 90 psi (6.2 bar) at the tool. When using the
®
Die Blaster 11 mm belt, a flow pressure of 75 psi (5.2 bar) at the tool is necessary.
Correct air pressure will increase the service life!
The supply of compressed air must be free of water. For this reason a water separator must be used to trap
condensate. If the compressed air hose is too long, the tool cannot be supplied with the necessary air pressure.
For correct operation and the long service life of the compressed air motor, the usage of a lubrication device in
the compressed air line is expressly recommended.
19