Montipower DIE BLASTER Mode D'emploi page 16

®
ENG Operating instructions Die Blaster
After maintenance tasks, all safety features removed must be correctly re-fitted.
The safety features and their protective action must be checked by an expert prior to placing the tool in operation.
Removing, disengaging and / or bypassing safety features (covers, trim panels, starter switch, etc.) and/or safety
guards can cause severe injury or damage and are therefore strictly forbidden by the manufacturer!
®
The manufacturer provides a warranty for the Die Blaster in accordance with its general terms and conditions.
Claims under the warranty will be void if:
- Damage is caused by improper operation,
- Repairs or modifications are made by unauthorised individuals,
®
- Accessories and spare parts are used that are not suitable for the Die Blaster .
®
Malfunctions must be reported immediately on detection. The Die Blaster must be marked correspondingly.
Defects are to be repaired without delay to minimise damage and to avoid degrading the safety of the tool.
Claims under the warranty will be rendered void if this instruction is not followed.
16