Temperature Setting - Blumfeldt Cosmic Beam Mode D'emploi

Temperature setting

• First press the SET button
DOWN button
pressed, the temperature is increased or decreased by 1 °C.
• The maximum temperature setting is 45 °C and the minimum temperature
setting is 5 °C. Finally, set the desired temperature and the system will
automatically save the set temperature and will return to operating mode,
displaying the room temperature.
Timing switch setting
• If you press the SET button
• Press the UP button
power off. Each time the button is pressed, the set time period increases
or decreases by 1 hour. The minimum time setting is 1 hour, the maximum
time setting 24 hours. Once you have set the time, the system will
automatically save it and return to the operating status. The temperature
and time to power off are displayed on the screen.
Function "Open window detection"
• If the room temperature decreases by 3 °C or more during heating
operation within 2 minutes, window open detection is activated and
heating operation is stopped. Meanwhile, the LED indicator flashes
accompanied by signal tones. The heating can only be put back into
operation manually.
Heating level setting
• During operation, press the HIGH/LOW button
the two heating levels (high or low).
Switch OFF
• Press the ON/OFF button
light will remain on even after switching off if the appliance is connected
to the socket.
CAUTION
Danger of burns! This heater heats up strongly when in use. Do
not touch the hot surface to avoid burns.
Set
, than press the UP button
, to adjust the temperature. Each time the button is
Set
, the display "00" will flash.
or DOWN button
, to switch off the appliance. The indicator
or the
to set the time to auto
and select one of
EN
27