Horizon Global 76926 Instructions D'installation page 9

6. Tighten all M10-1.25 CL8.8 fasteners with torque wrench to 42 Lb.-Ft. (57 N*M)
7. Trim fascia –Locate the center of the fascia. Using a tape measure, marker, and utility knife, cut a notch in the bottom of fascia approximately 8'' wide by 6" tall. See
Figure 3. Note: Be sure area is clear of all electrical wiring before trimming. Slightly bend up the metal tab on end panel near right-hand side chain bracket. Push-pin
rivet will not be reinstalled to this metal tab.
©2022 Horizon Global Americas Inc. - Printed in Mexico
Proper torque is needed to keep the hitch secure to the vehicle
when towing.
Sheet 9 of 30 76926NP 7/5/22 Rev. A