Horizon Global 76926 Instructions D'installation page 8

3. Remove bumper beam – If equipped, disconnect the blind spot monitor wire
from top of bumper beam. Set bumper beam aside. Keep hex flange nuts for
hitch installation. Return factory hex bolts and bumper beam to vehicle owner.
See Figure 1.
5. Install Hitch and Bumper beam - NOTE: Apply blue thread locker to all fasteners. Raise the hitch into position, inserting the tabs into the frame
rail. Fish wire 7/16" carriage bolts ①and spacers ② into place through the hole in the side plate and out the bottom of the frame rail, attach
7/16 flat washers ③ , lock washers ④, and nuts ⑤onto the carriage bolts See Figure 1. Install the bumper over the hitch, loosely install (2) M10
nuts ⑨ and 3/8" conical washers (teeth side toward hitch) ⑧ onto the studs, and (4) M10 hex bolts ⑦ and 3/8"conical washers ⑧ into weld
nuts in end panel. If equipped, reconnect blind spot monitor wire to top of bumper.
©2022 Horizon Global Americas Inc. - Printed in Mexico
4. Apply sealant - apply silicone sealant to both hitch bracket
mounting surfaces. See Figure 2.
Not included
Sheet 8 of 30 76926NP 7/5/22 Rev. A