Routing Cables; Installing The Power Cord Strain Relief - Dell PowerEdge 1750 Guide D'installation

5X860eb0.fm Page 14 Monday, October 21, 2002 11:49 AM
7
8
9
10
F i g u r e 1 - 1 0 .

Routing Cables

1
1-14 Rack Installation Guide
All manuals and user guides at all-guides.com
Route the status-indicator end of the cable assembly through the cable-management
arm, and install the indicator in its slot at the back end of the cable-management arm
(see Figure 1-9).
Connect the power cords to their receptacles on the back panel.
NOTICE: Although the strain-relief can accommodate power cords with a bend radius
of up to 19 mm (0.75 inch), the system manufacturer recommends that you only use
the power cords provided with the system.
Install a tie-wrap through the slot on the strain-relief tab (see Figure 1-10).
Bend the power cords back beside the power receptacle housing, forming a tight loop,
and install the strain-relief tie-wrap loosely around the looped power cords (see
Figure 1-10).
I n s t a l l i n g t h e P o w e r C o r d S t r a i n R e l i e f
Attach the I/O cable connectors to their respective connectors on the system back.
For details on cable connections, see your system's Installation and Troubleshooting
Guide and the User's Guide.
power cord strain-relief tab and tie wrap
power receptacle housing
power cord plug