Warnings - Graco 127650 Mode D'emploi

B1

WARNINGS

EN
The following warnings are for the setup, use, grounding, and repair of this equipment. The
exclamation point symbol alerts you to a general warning and the hazard symbols refer to
procedure-specific risks. When these symbols appear in the body of this manual or on warn-
ing labels, refer back to these Warnings. Product-specific hazard symbols and warnings not
covered in this section may apear thoughout the body of this manual where applicable.
FIRE AND
When flammable fluids
EXPLOSION are present in the work
area, such as gasoline and
windshield wiper fluid,
be aware that flammable
fumes can ignite or ex-
plode. To help prevent fire
and explosion:
EQUIPMENT Misuse can cause death
MISUSE or serious injury
!
Toxic Fluid
Toxic fluids or fumes can
or Fumes cause serious injury or
Hazard death if splashed in the
eyes or on skin, inhaled, or
swallowed.
4
WARNING
Use equipment only in will ventilated area.
Eliminate all ignition sources, such as
cigarettes and portable electric lamps.
Keep work area free of debris, including rags
and spilled or open containers of solvent and
gasoline.
Do not plug or unplug power cords or turn
lights on or off when flammable fumes are
present.
Ground all equipment in the work area.
Stop operation immediately if static spark-
ing occurs or if you feel a shock. Do not use
equipment until you identify and correct the
problem.
Keep a working fire extinguisher in the work
area.
Do not operate the unit when fatigued or un-
der the influence of drugs or alcohol.
Do not exceed the maximum working pres-
sure or temperature rating of the lowest rated
system component. See Technical Data in all
equipment manuals.
Use fluids and solvents that are compatible
with equipment wetted parts. See Technical
Data in all equipment manuals. Read fluid
and solvent manufacturer's warnings. For
complete information about your material,
request MSDS from distributor or retailer.
Do not leave the work area while equipment
is energized or under pressure.
Turn off all equipment when equipment is
not in use.
Check equipment daily. Repair or replace worn
or damaged parts immediately with genuine
manufacturer's replacement parts only.
Do not alter or modify equipment. Altera-
tions or modifications may void agency ap-
provals and create safety hazards.
Make sure all equipment is rated and approved
for the environment in which you are using it.
Use equipment only for it intended purpose.
Call your distributor for information.
Route hoses and cables away from traffic areas,
sharp edges, moving parts, and hot surfaces.
Do not kink or over bend hoses or use hoses
to pull equipment.
Keep children and animals away from work area.
Comply with all applicable safety regulations.
Read MSDS's to know the specific hazards of
the fluids you are using.
Store hazardous fluid in approved contain-
ers, and dispose of it according to applicable
guidelines.
M0303