Operation; Power On/Off - auna V-14 DAB Mode D'emploi

OPERATION

• Short press the Power button on the front of your Micro System.
The first time you switch on your Micro it will start in CD mode,
subsequently.
• It will start in the mode you were last using unless it has been
unplugged from the mains power supply.
Power connection
1. Fully extend the wire radio aerial on the back of the Micro to receive the
best possible radio reception and sound quality.
2. Connect the mains power lead into the bottom power socket behind the
right hand speaker on the side of your Micro.
3. Plug the mains power plug into the mains power wall socket and switch
on. Your Micro will now be in Standby mode.
4. Pull out the safety strip on the remote control to activate the battery.
Set the clock
1. With the Micro in Standby mode, long press the Clock button on the
remote control until 24H flashes in the display.
2. Use the Vol+ or Vol- on the remote control to change between 24H and
12H. Short press the Clock button on the remote control to confirm.
3. The clock digits will now flash. Use the Vol- button on the remote
control to set the hour and Vol+button to set the minutes. Short press
the Clock button on the remote control to confirm. The clock digits will
stop flashing and the clock time is now set.

Power on/off

• Short press the Power button on the Micro or on the remote control to
power on your product.
• Short press the Power button on the Micro or on the remote control.
Your Micro will go to Standby mode and the clock will be displayed.
EN
39