Publicité
Les langues disponibles
Les langues disponibles
Contents • Contenu • Inhalt • Inhoud • Contenidos • Innehåll • Innhold • Sisältö • Indhold • Indice • Conteúdo
Zawartość • Περιεχόμενα • İçindekiler • Tartalom • Obsah • Содержание • Sisukord • Saturs • Turinys
x1
Assembly • Assemblage • Montage • Samenstelling • Montaje • Montering • Montering • Kokoaminen • Montering
Montaggio • Montagem • Montaż • Συγκρότημα • Montaj • Összeszerelés • Sestava • Сборка • Koostamine
1
2
5
GB
Thank you for choosing a Hozelock quality sprayer, you can be
assured of many years of reliable service from this product.
Instructions & Warnings
• This Sprayer is intended for use with liquid bleach diluted at
2% to 5% maximum with water (100ml to 250ml maximum
for 5L of water) - Do not use for gardening afterwards.
• Always follow the chemical suppliers instructions, as well as
the instructions supplied with this sprayer.
• Make sure all nuts are screwed hand tight before use.
• Discard safely any unused solution after use.
• Always use eye protection when replacing valves, seals or
springs.
• Before carrying out any maintenance on this sprayer
it is essential to depressurise the bottle, by lifting the
pressure release knob.
Only use bleach diluted with water in this product.
Do not use with any other chemicals.
Always wear protective clothing, goggles,
face mask and gloves.
Avoid inhaling spray mist.
Avoid skin contact with chemicals.
Always work in a well ventilated area.
Take care to protect children, pets & fish from exposure
to chemicals.
Always wash hands thoroughly after use & especially
before eating.
Cuprins • Зміст • Vsebina
x1
Montāža • Surinkimas • Ansamblu • Монтаж • Sestav
3
6
x1
x1
4
7
Always wash any contaminated clothing.
Seek medical attention if spray gets in your eyes or you
develop any symptoms after spraying.
Spray only thin watery solutions; thicker mixtures will clog
the nozzle.
If the material to be sprayed contains sediment, strain the
liquid into the sprayer bottle.
Do not over pressurize the bottle. The pressure release
valve is designed to release excess pressure, and must not
be tampered with, or forced to remain closed.
Winter use – drain liquid from all parts and loosen pump
assembly.
Annual maintenance – At least once per year thoroughly
clean the whole sprayer and apply silicone grease to all
moving parts & seals. Test with water, and if any washer or
seal has perished it must be replaced.
This sprayer is made from many different types of plastic,
and although the liquid you wish to spray may be packed
in plastic, this does not guarantee it will not damage
the sprayer. If you have any doubt about compatibility
contact Hozelock consumer services.
When filling the sprayer ensure that the maximum fill level
is not exceeded.
Ensure that the pump is screwed into the bottle tightly.
After use with chemicals, fill sprayer with warm water
(not hot), re-assemble the sprayer and spray some of
the contents. Repeat; check that the nozzle is free from
sediment.
x1
Publicité
