NEC MultiSync LCD1880SX Mode D'emploi page 21

Appendix
OSM Lock Out
OSM Rotation
Resolution Notifier
Factory Preset
Tag8 Video Band Width
(Analog input only)
Sync Threshold
(Analog input only)
SOG Correction
(Analog input only)
Tag9 Display Mode
Monitor Info
–continued
This control completely locks out access to all OSM control functions. When
attempting to activate OSM controls while in the Lock Out mode, a screen will
appear indicating the OSM controls are locked out. To activate the OSM LockOut
function, press SELECT, then + key and hold down simultaneously. To de-activate the
OSM Lock Out, press SELECT, then + key and hold down simultaneously.
CONTRAST and BRIGHTNESS can be adjusted while in the lock out mode.
To switch OSM between Landscape and Portrait modes. Press "+" or "-" to
select.
The optimal resolution is 1280 x 1024. If ON is selected, a message will
appear on the screen after 30 seconds, notifying you that the resolution is not
set to 1280 x 1024. Press "+" or "-" to select.
Selecting Factory Preset allows you to reset all OSM control settings back to
the factory settings. Highlighting the control to be reset and pressing the
RESET button can reset individual settings. Press "SELECT" to reset.
It is used when the unnecessary noise from computer appears on a screen. It is
strong ineffective, so that a number becomes small. Press "+" or "-" to select.
Adjusts the slice level of a synchronization signal. Press "SELECT" to move the
adjustment menu.
SEP./COMP.: Adjusts the sensitivity of the separate or composite input signals.
Try this option if the FINE adjustment does not successfully eliminate the noise.
Sync On Green: Adjusts the sensitivity of the Sync On Green input signals.
Adjusts the slice level when separating a synchronization from sync On Green
signal input. Press "+" or "-" to select.
Shapes the waveform of the Sync On Green signals. Try this option if the FINE
adjustment does not eliminate the noise produced after the signal cable has
been extended. Press "SELECT" to move adjustment menu.
OFF
The inputted synchronization signal is used as it is.
AUTO
Shapes the waveform according to the input waveform automatically. The
signal which has not deteriorated is used as it is.
ON
Corrects the waveform irrespective of the input waveform.
Provides information about the current display resolution and technical data,
including the preset timing currently being used and the horizontal and
vertical frequencies. Increases or decreases the current resolution. Press
"SELECT" to move the adjustment mode, and press "+" or "-" to adjust.
Indicates the model and serial numbers of your monitor.
21