NEC MultiSync LCD1880SX Mode D'emploi page 19

Appendix
Tag4 Auto
(Analog input only)
H. Position
V. Position
H. Size
(Analog input only)
Fine
(Analog input only)
Tag5 Auto Fine
(Analog input only)
Black Level
(Analog input only)
Tag6 Color Control
–continued
Automatically adjusts the Image Position and H. Size settings and Fine
settings. Press "SELECT" to activate Auto Adjustment.
Controls Horizontal Image Position within the display area of the LCD. Press
"+" or "-" to adjust.
Controls Vertical Image Position within the display area of the LCD. Press "+"
or "-" to adjust.
Adjusts the horizontal size of the screen.
Should the "AUTO Adjust function" do not give you a satisfactory picture
setting, a further tuning can be performed using the "H.Size" function (dot
clock). For this a Moiré test pattern could be used. This function may alter the
width of the picture. Use left/Right Menu to center the image on the screen. If
the H.Size is wrongly calibrated, the result would look like on the left drawing.
The image should be homogeneous.
When H.SIZE value is wrong.
Improve focus, clarity and image stability by increasing or decreasing this
setting.
Should the "Auto Adjust function" and the "H.Size" function do not give you a
satisfactory picture setting, a fine tuning can be performed using the "Fine"
function. It improves focus, clearity and image stability by increasing or
decreasing this setting. For this a Moiré test pattern could be used. If the Fine
value is wrongly calibrated, the result would look like on the left drawing. The
image should be homogeneous.
This function automatically and periodically adjusts the "FINE" setting for change
in signal condition. This function adjusts approximately every 33 minutes or when a
change in signal timing is detected.
Adjusts the black level. Press "+" or "-" to select.
MANUAL allows you to manually adjust the black level. Press "+" or "-" to
adjust.
AUTO automatically adjusts the black level. Ensure that the image has 64 or
more adjacent black dots before making an adjustment. Press "SELECT" to
activate Auto Adjust.
Six colors for the desired color setting (NATIVE color preset cannot be
changed).
Color temperature increases or decreases in each preset. Press "
to select color. Press "+" or "-" to adjust. Press "SELECT" to customize.
R,Y,G,C,B,M,S
Increases or decreases Red, Yellow, Green, Cyan, Blue, Magenta and
Saturation depending upon which is selected. The change in color will appear
on screen and the direction (increase or decrease) will be shown by the color
bars. Press "+" or "-" to adjust.
NATIVE
Original color presented by the LCD panel that is not adjustable.
When H.SIZE value is improved. When H.SIZE value is correct.
When FINE value is wrong. When FINE value is correct.
19
" or " "