Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Read and follow all instructions and Safety warnings before using this
The FLG5 Suction feed Spraygun is fitted with a 1.8mm Nozzle for topcoat
applications .
The FLG5 Spraygun is approved to ATEX regulations 94/9/EC, protection level;
Important: These Sprayguns are suitable for use with both waterbased and solvent
based coating materials. The design uses EPA compliant atomising (Devilbiss Trans-
Tech®) technology to reduce overspray and improve coating efficiency. Nozzles and
Needles are manufactured in Stainless Steel. These guns are not designed for use
with highly corrosive and/or abrasive materials and if used with such materials it must
be expected that the need for cleaning and/or replacement of parts will be increased. If
there is any doubt regarding the suitability of a specific material contact your local
Distributor or Finishing Brands UK Limited direct.
Air supply connection –
Maximum static air inlet pressure –
Nominal gun inlet pressure with gun triggered – 2.4 bar (35 psi)
Maximum Service temperature –
Gun Weight –
Airflow –
Gun body
–
Nozzle
–
Needle
–
Cup
–
Finishing Brands UK Limited reserves the right to modify equipment specification without prior notice.
© 2012 Finishing Brands UK Ltd.
Important
equipment
Description
II 2 G X, Suitable for use in Zones 1 and 2
SPECIFICATION
Materials of Construction
Aluminium
Stainless steel
Stainless Steel
Aluminium and Steel
EN
EN
Universal
P
= 12 bar (175 psi)
1
40°C
930g
277 l/min (9.8 cfm)
2
1
/
BSP and NPS
4
Publicité
Table des Matières
