Table des Matières
Publicité
3
4
A chaque fois que vous mettez
votre casque, vérifiez qu'il corres-
pond bien à votre taille, comme expliqué
page 4.
textileS • textile PartS
MISE EN PLACE - INSTALLATION
INSTALLATION
1. Cap fabric :
Slide the front in its support.
The clips must be correctly locked. Clip
the 2 snaps holding the rear of the cap.
2. Cheeks :
Place the belt in the central
of cheek pads, clip the cheek pads. Well
apply the top part of cheek pads at the
level of vision field (Velcro).
IMPORTANT :
Check the belt does not
present any folds under the cheek pads.
3. Neck protective :
of hard rear part between the shell and
polystyrene.
Attention :
not to deteriorate the polysty-
rene. Do the same for the front. Check the
proper balancing. Slide the frame under
the joints (see photos.)
4. Belt protection :
protection ; be careful to fix them to the
good length to adjust the magnetic clasp.
Attention not to reverse the side of belt
protection (see photos)
WARNINg : If you have any doubt
whatsoever regarding the remo-
val or replacement of the interior pad-
ding, do not uSe your helmet.
Contact your retailer for assistance or
advise. NEVER use your helmet with
any part of the interior padding remo-
ved. The helmet will not protect you in
an accident.
Each time you put on your helmet,
check the fit as discussed on page 10.
Insert the maximum
Reposition the belt
25
Publicité
Table des Matières
