Torin BIG RED T42002A Manuel Du Propriétaire page 5

ASSEMBLY INSTRUCTIONS
In order to prevent removal of the post from the base use a hammer and flat end punch to hammer the jack's
tab in toward to post but not touching the post. Same stands are equipped with a bolt instead of the tab. In
this case the bolt can be threaded in toward the post until the bolt bottoms out.
Item: T42002A, T43002A, T46002A
1. Install ratchet bar into frame (fig.1) with ratchet portion of bar aligned with locking pawl (stopper).
2. Move the ratchet bar to its lowest position by raising the locking handle, thereby releasing the stopper, and
guiding the bar downward (fig. 2).
3. Bend metal tab in (Fig. 3) using a hammer and punch. This will help prevent inadvertent separation of the
ratchet bar from base frame.
4. Insert double locking pin (Fig. 4).
fig.1
Item: T412002A
1. Install ratchet bar into frame (fig.1) with ratchet portion of bar aligned with locking pawl (stopper).
2. Move the ratchet bar to its lowest position by raising the locking handle, thereby releasing the stopper, and
guiding the bar downward (fig. 2).
3. Tightening the bolt (Fig 3) using a wrench. This will help prevent inadvertent separation of the ratchet bar
from base frame.
4. Insert double locking pin (Fig. 4).
fig.1
fig.2
fig.2
fig.3
Metal tab
fig.3
Tightening
the bolt
5
fig.4
Double
locking pin
fig.4
Double
locking pin