Beaba c1na37tpxps Notice D'utilisation page 7

INSTANT PREPARATION MODE
• The instant preparation mode is the fastest mode for preparing bottles.
Only a few seconds are needed for the bottle to reach the right temperature
(about 37°C).
• Fill the bottle with the required amount of room temperature or cold water.
• Open the lid and pour the water into the empty heating unit.
• Close the lid.
• Press the button . The button flashes during the heating process.
Heating time may vary depending on the amount of water and the initial
temperature.
• As soon as the water has reached the correct temperature (about 37°C),
the button remains alight and the device beeps three times.
• Then, fill the bottle with the required amount of powdered milk and place
it on the receptacle grid.
• Press down on the water distribution button until the bottle has been filled.
• Check that all the water has been emptied from the heating unit.
• A small amount of water may be left at the bottom of the heating unit. Dry it
with a clean cloth or tip the device forwards and press down on the water
distribution button until no water is left inside.
• To switch off the device, press the button again
• For hygiene reasons, and in order to avoid any microbiological risks, the
bottle should be consumed quickly after preparation (within 2 hours). Before
preparing any food, please consult a health professional or your paediatrician
for further information about food safety and preparation (water to use,
storage, preparation methods, etc.). Please also refer to the instructions
provided with your milk or baby food jars for any specific recommendations.
ATTENTION! For hygiene reasons, the water distribution mode
may be used with water only.
BAIN-MARIE MODE
• Bain-Marie mode is for heating bottles and food jars.
• The bain-marie mode does not enable the temperature to be controlled
with precision. Heating time should be adapted according to the quantity
and the initial temperature of the food and the type of container used.
Always check the temperature of food before feeding your child.
.
12
• Always ensure that the device is unplugged and that the heating unit is
empty before removing the heating unit from its base.
• Open the lid of the heating unit.
• Fill the heating unit with water up to the "Max" line.
• Place the bottle or the jar to be heated in the heating unit.
• Press the button or the button
be reheated and the food's initial temperature:
Button 1: room temperature – small amount – about 7 minutes
Button 2: fridge temperature – large amount – about 13 minutes
• At the end of the heating cycle, the control button selected switches off
and the device beeps three times.
• Remove the bottle or the food jar with a cloth in order to avoid burns.
• After mixing the content of the food jar or shaking the bottle, always check
that the food is not too hot and that there is no risk of burning your child.
• In Bain-Marie mode, the product may be used with or without the base.
• To remove the heating unit from the base, remove the steriliser/bottle
compartment.
• Remove the power cable from the cable storage compartment and turn
the heating unit's unlocking button clockwise.
• Press down on the unlocking button and lift the heating unit from front to
back.
• For hygiene reasons, and in order to avoid any microbiological risks, the
bottle should be consumed quickly after preparation (within 2 hours).
Before preparing any food, please consult a health professional or your
paediatrician for further information about food safety and preparation
(water to use, storage, preparation methods, etc.). Please also refer to
the instructions provided with your milk or baby food jars for any specific
recommendations.
Never use water which has been used for a bain marie to prepare
feeding bottles.
CLEAN MODE
• For hygiene reasons, the device is fitted with a self-cleaning function which
sterilises the device automatically.
• Pour about 100 ml of water into the heating unit.
• Close the lid and press the button
depending on the quantity to
.
13