Craftsman 919.724591 Mode D'emploi page 19

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

12. Replace the outlet tube and
tighten nuts.
13. Replace shrouds and console.
14. Perform the Break-in Procedure.
See "Break-in Procedure" in the
Operation section.
To Replace Regulator
1.
Release all air pressure from air
tank. See "To Drain Tank" in the
Maintenance section.
2.
Unplug unit.
3.
Remove the regulator ring and
remove the console cover,
gauge and quick connect. Orient
outlet pressure gauge to read
correctly. Tighten quick connect
with wrench.
Regulator
Ring
4.
Using an adjustable wrench
loosen pressure relief tube nut at
air tank and pressure switch.
5.
Using an adjustable wrench,
rotate the pressure switch
assembly as shown.
Regulator
Outlet
Pressure
Gauge
6.
7.
8.
9.
NOTE: Arrow indicates flow of
air. Make sure it is pointing in the
direction of air flow.
Cover
10. Reapply pipe sealant to outlet
11. Reassemble outlet pressure
12. Rotate pressure switch assemble
13. Replace console cover and
Tank
Pressure
Gauge
Quick
Connect
19 - ENG
Remove the outlet pressure
gauge, tank pressure gauge, and
quick connect (if equipped) from
the regulator.
Remove the regulator.
Apply pipe sealant tape to the
nipple.
Assemble the regulator and
orient as shown.
Regulator
Arrow
pressure gauge, tank pressure
gauge, and quick connect.
gauge,tank pressure gauge, and
quick connect. Orient outlet
pressure gauge and tank
pressure gauge to read correctly
Tighten quick connect with
wrench.
into correct position.
regulator ring.
A14841

Publicité

Table des Matières
loading

Table des Matières