FULL OVERLAY PANEL INSTALLATION INSTRUCTIONS
Step 2: Size the Overlay Panel
Cut the overlay panel to the dimensions shown below in
Figure 12 and Table A.
This is also a convenient time to locate and drill the holes
for your handle. Most often the handle is to match that of
the surrounding cabinetry. If your handle attaches from the
back-side of the custom panel, locate the mounting holes
while the panel is attached to the drawer and cabinet. After
the panel is removed from the drawer, drill the mounting
holes from the front, to the recommended diameter of the
handle manufacturer. Counter bore the back-side of the
panel so the screw heads do not interfere with the surface
of the drawer.
Panel thickness
15
⁄
"
3
16
(385.8 mm)
Face of RDE
Overlay Panel
Model
6RDE
23
⁄
5
8RDE
29
⁄
5
8
Table A
All manuals and user guides at all-guides.com
Dim "A"
Figure 12
Dim "A"
"(600.2mm)
8
" (752.6mm)
Step 3: Attach the Overlay Panel to the Drawer
1. Set the overlay panel on drawer front face and align
edges. (See Figure 13 below). Clamp panel in position
and mark pilot hole locations. Pick the required pilot
hole size from "Table B" below and drill the pilot holes
ensuring not to drill all the way through the overlay
panel.
Table B: Pilot Hole Drill Sizes for Wood Screws
Material Type
Hardwood
Softwood
2. Insert wood screws through clearance holes and
tighten to secure overlay panel.
3. Reinstall gasket into channel. Make sure the corners
are fully inserted.
Step 4: Reinstall the Drawers
1. Fully extend drawer slides and place drawer on slides.
Be sure that drawer sits evenly on both slides and clips
slide into place in rear of drawer.
2. Re-install two screws through drawer into slides.
Screw clearance
hole through
gasket extrusion
Figure 13
14
#8 Wood Screw
⁄
Dia. Pilot Hole
1
8
⁄
Dia. Pilot Hole
7
64
Overlay panel
flush with
edges of drawer
front
Using clearance holes in
gasket channel mark
hole locations onto panel