Publicité
Door Adjustment Section
STEP 6
To add tilt to your
door: Tighten or loosen
"Adjustment Screw" until
cabinet door is at desired
position.
whether it be to the left,
right, top, or bottom, use the
adjustment screw
(Figure 6A).
Note: Each corner can be
adjusted independently.
STEP 7
To adjust your cabinet door
side to side use a 3/8" nut
driver, you will want to use
the "Lock Nut" adjustment,
refer to Figure 7 for the
"Lock Nut" location.
Note: All "Lock Nuts" must
be loose in order for the do
or to move completely left
or right.
3
8
STEP 8
Tighten "T-Nut" to lock filler
against adjustment screws
(Figure 7).
RUB BUSHING INSTALLATION
STEP 9
Install the rub bushings
using the provided kit and
instructions.
Note: Base unit will need
to be removed from the
cabinet by disengaging the
slides for the bushings to be
installed.
4
FIG. 6
FIG. 7
Lock Nut / T-Nut
Customer Service: 800-626-1126 | rev-a-shelf.com
Adjustment Screws
Publicité
