Stadler Form Peter Mode D'emploi page 7

4. Press the button for the selection of "Natural Breeze" mode (8) for natu-
ral wind conditions. The blue LED beneath the button (8) will now light
up. This mode provides an even more pleasant cooling effect, simulat-
ing a natural breeze. The fan speed of this breeze automatically varies
depending on the selected speed level.
5. By pressing the button for the timer (9) you can set the operating time
for between 1 and 7 hours (for example, 3 h = 1 h and 2 h LEDs lit, 7 h =
1 h, 2 h and 4 h LEDs lit). The selected time is displayed below the timer
button (9) with blue LEDs. Press once to set the operating time to 1 h,
press the button again for 2 h, and so on. The remaining time is indicated
by the illuminated LEDs below the timer button (9). The unit switches
off automatically after the set operating time has elapsed. If no LEDs
are lit below the timer button (9), the unit is set to continuous operation.
6. Activate swing mode by pressing the swing mode button (10). The appli-
ance now swings at an angle of approx. 70° to ensure optimum distribu-
tion of cooling air throughout the room. Press the swing mode button (10)
again if the appliance is to remain at a certain angle.
7. Switch off the appliance by pressing the on/off button (4).
8. The remote control (11) is in the compartment for remote control (12)
on the back of the appliance. It operates via infrared – for this purpose,
point the remote control at the infrared receiver (14) on the front of the
unit. The battery compartment (13) is on the back of the remote control
(11). This can be opened by pushing the cover downwards.
Cleaning
Prior to any maintenance, cleaning and after each use, switch off the appli-
ance and unplug the mains cable (3) from the socket.
Attention: Never submerge the appliance in water (danger of short-circuit).
• For external cleaning, rub with a damp cloth and then dry thoroughly.
• Make sure that the air inlet (16) and air outlet (15) are cleaned regularly
to prevent the build-up of dust. The air outlet (15) can be cleaned with a
dry brush or a vacuum cleaner. The air inlet screen (16) is fitted with an air
filter which can be removed and cleaned with a damp cloth. Remove the
filter by removing the 4 screws on the air inlet screen (16). After cleaning,
ensure that the air filter is completely dry and that the 4 screws are firmly
tightened again.
Repairs
• Repairs to electrical appliances must only be carried out by a qualified
electrical technician. If improper repairs are carried out, the warranty
lapses and all liability is refused.
• Never operate the appliance if the adaptor or plug is damaged, after it has
malfunctioned, if it has been dropped or has been damaged in any other
way (cracks/breaks in the casing).
• Do not push any object into the appliance.
• If the appliance is beyond repair, make it unusable immediately by cutting
through the cable and hand it in at the collection point provided for the
purpose.