Extracting The Removable Plate; Commissioning - SilverCrest SWEW 750 A2 Mode D'emploi

Extracting the removable plate

1) Upper removable plate: Slide the locking devices 1 upwards and simul-
taneously tilt the removable plate forward so that you can lift it out from
underneath the lower mountings 3.
2) Lower removable plate: Pull the locking devices 5 forward and lift the
removable plate so that you can pull it out from the rear mountings 6.

Commissioning

Carry out the following procedure with each of the 3 pairs of removable plates.
■ Smear the non-stick coating on the removable plates with oil suitable for cooking.
WARNING! RISK OF INJURY!
► Let the appliance cool down before exchanging the removable plates!
Risk of Burns!
■ Install a pair of removable plates into the appliance.
■ Insert the plug into a mains power socket.
Close the appliance and lock it with the lid locking device 0.
■
■ Let the appliance heat up for about 10 minutes.
NOTICE
► With the fi rst usage a slight smell can arise (minimal smoke development is
also possible). This is normal and dissipates after a short time. Provide for
suffi cient ventilation. For example, open a window.
■ Disconnect the plug and allow the appliance to cool down.
■ Clean the removable plates and the appliance as described in the chapter
"Cleaning".
The appliance is now ready for use.
■ 46 │
GB
SWEW 750 A2