Technical Data; Symbols; Intended Use - Festool RAS 115 E Guide D'utilisation

back will propel the tool in direction opposite to
the wheel's movement at the point of snagging.
d) Use special care when working corners, sharp
edges etc. Avoid bouncing and snagging the
accessory. Corners, sharp edges or bouncing
have a tendency to snag the rotating accessory
and cause loss of control or kickback.
e) Do not attach a saw chain woodcarving blade or
toothed saw blade. Such blades create frequent
kickback and loss of control.
Safety Warnings Specif-
ic for Sanding Operations
a) Do not use excessively oversized sanding disc
paper. Follow manufacturers recommenda-
tions, when selecting sanding paper. Larger
sanding paper extending beyond the sanding
pad presents a laceration hazard and may cause
snagging, tearing of the disc or kickback.
TO REDUCE THE RISK OF INJURY,
USER MUST READ INSTRUCTION MANUAL.
Various dust created by power sanding,
sawing, grinding, drilling and other construction
activities contains chemicals known (to the State
of California) to cause cancer, birth defects or
other reproductive harm. Some examples of these
chemicals are:
• Lead from lead-based paints,
• Crystalline silica from bricks and cement and
other masonry products,
• Arsenic and chromium from chemically-treated
lumber.
The risk from these exposures varies, depending
on how often you do this type of work.
To reduce your exposure to these
chemicals work in a well ventilated
area and use approved safety equip-
ment, such as dust masks that are spe-
cially designed to fi lter out microscopic
particles.

Technical data

Wattage
Speed
Max. speed*
Sanding base dia.
Spindle thread
Weight
Safety level
*Max. possible speed with faulty electronics.
Warning of general danger
Read the Operating Instructions/Notes!
Wear ear protection.
Wear eye protection.
Wear a dust mask!
V Volts
A Amperes
Hz Hertz
W Watt
~ Alternating current
n Speed
Class II Construction
-1
rpm/ min Revolutions per minute
Ø Diameter

Intended use

The RAS 115 E is designed for sanding wood, plas-
tics, stone, composite materials, paints / lacquers,
fi llers, stoppers and similar materials.
Never use the tool for grinding or cut-
ting metal. Materials containing asbestos must not
be processed.
Never fasten grinding disks on the
tool. Work only with the provided sanding pad and
whereupon fastened abrasives.
The device is unsuitable for wet sand-
ing for reasons of electrical safety.
6
4000 min
5000 min
115 mm (4.5 in.)
1.6 kg (3.5 lbs.)

Symbols

500 W
-1
-1
M 14
/ II