Maintenance; General; Daily Cleaning; Draining The Dispenser - Hatco AWD Série Manuel D'installation Et D'utilisation

English

General

Hatco Atmospheric Hot Water Dispensers are designed for
maximum durability and performance with minimum maintenance.
WARNING
ELECTRIC SHOCK HAZARD:
• Turn OFF power switch, unplug power cord, and allow
unit to cool before performing any cleaning,
adjustments, or maintenance.
• DO NOT submerge or saturate with water. Unit is not
waterproof. Do not operate if unit has been submerged
or saturated with water.
• Do not steam clean or use excessive water on unit.
• This unit is not "jet-proof" construction. Do not use jet-
clean spray to clean this unit.
• Use only Genuine Hatco Replacement Parts when
service is required. Failure to use Genuine Hatco
Replacement Parts will void all warranties and may
subject operators of the equipment to hazardous
electrical voltage, resulting in electrical shock or burn.
Genuine Hatco Replacement Parts are specified to
operate safely in the environments in which they are
used. Some aftermarket or generic replacement parts
do not have the characteristics that will allow them to
operate safely in Hatco equipment.
This unit has no "user-serviceable" parts. If service is
required on this unit, contact an Authorized Hatco Service
Agent or contact the Hatco Service Department at
800-558-0607 or 414-671-6350.
NOTICE
Clean unit daily to avoid malfunctions and maintain
sanitary operation.

Daily Cleaning

To preserve the finish of the Atmospheric Hot Water Dispenser,
it is recommended that the exterior surfaces be wiped daily with
a clean, damp cloth.
WARNING
Submerging or saturating unit with water will damage the
unit and void unit warranty.
NOTICE
Use non-abrasive cleaners and cloths only. Abrasive
cleaners and cloths could scratch finish of unit, marring
its appearance and making it susceptible to soil
accumulation.
1. Wipe the exterior surface of the unit with a damp cloth.
2. Stubborn stains may be removed with a good stainless
steel cleaner or a non-abrasive cleaner. Hard to reach
areas should be cleaned with a small brush and mild soap.
3. Wipe dry the entire unit using a dry, non-abrasive cloth.
Form No. AWDm-1016

Draining the Dispenser

It is recommended that the dispenser be drained prior to moving
the unit and after performing the "Deliming the Dispenser"
procedure.
ELECTRIC SHOCK HAZARD: Turn OFF power switch,
unplug power cord, and allow unit to cool before
performing any cleaning, adjustments, or maintenance.
1. Shut off the water supply to the unit.
2. Turn the POWER ON/OFF (I/O) switch to the OFF (O)
position and unplug the unit from the electrical receptacle.
3. Connect drain hose to the drain fitting on underside of unit.
4. Place open end of drain hose in a bucket or open site drain
in a manner acceptable to local plumbing codes.
5. Open the drain valve by placing the drain handle in the
vertical position.
6. After all of the water is drained, place the valve handle in
the horizontal position to close the valve.
7. Remove the drain hose from the drain fitting.
Drain Valve
Handle
(open position)
Draining the Water
9

MAINTENANCE

WARNING
Drain Fitting