Operation; General; Dispensing Hot Water - Hatco AWD Série Manuel D'installation Et D'utilisation

English

General

Use the following procedures to operate an Atmospheric Hot
Water Dispenser.
WARNING
Read all safety messages in the Important Safety
Information section before operating this equipment.
Hatco Corporation is not responsible for the actual food
product serving temperature. It is the responsibility of the
user to ensure that the food product is held and served at
a safe temperature.
Startup
NOTE: Make sure the drain valve handle is in the horizontal
(closed) position.
1. Plug unit into a properly grounded electrical receptacle of
the correct voltage, size and plug configuration. See the
SPECIFICATIONS section for details.
2. move the POWER ON/OFF (I/O) switch to the ON (I)
position.
• The WATER TEmPERATURE display will light up to
indicate power is supplied to the unit.
CAUTION
BURN HAZARD: Some exterior surfaces on unit will get
hot. Use caution when touching these areas.
3. The unit is ready to dispense water when the display
shows the setpoint water temperature (the factory default
setpoint temperature is 195°F [91°C]).
• The WATER TEmPERATURE display will show "E3"
while the water begins to fill the tank.
• The WATER TEmPERATURE display will show the
current water temperature and a red light will glow in the
upper left-hand corner of the digital temperature display
when the heating elements are energized.
• The water fills the tank until it is full and the heating
elements heat the water until the water temperature
reaches the setpoint temperature.
NOTE: A temperature setting higher than 195°F (91°C) will
cause nuisance tripping of the high limit switch and is
not recommended. If temperature adjustments are
required see "Programming The Dispenser." To reset
the high limit switch, see "Resetting The High
Temperature Limit Switch."
Shutdown
1. move the POWER ON/OFF (I/O) switch to the OFF (O)
position.
• The WATER TEmPERATURE display will turn off to
indicate power has been shut off to the unit.
Form No. AWDm-1016

Dispensing Hot Water

1. Place the proper water container for holding hot water on
the shelf (or below the dispenser) before dispensing.
NOTE: The shelf can be removed to dispense water into larger
containers. To remove the shelf, lift the shelf up and off
the mounting screwheads.
2. Push the appropriate button on the electronic temperature
controller to fill a container. Dispensing is controlled by the
four dispensing buttons on the front of the unit.
• The three VOLUmE SELECTION buttons underneath
the display dispense at pre-measured quantities of 2QT,
3QT, and 4QT as marked.
• 2QT = 2 quarts (1.9 liters)
• 3QT = 3 quarts (2.8 liters)
• 4QT = 4 quarts (3.8 liters)
• The red button dispenses and stops water manually.
• Press and hold to dispense water manually. Water
will continue to flow until the red button is released.
• Press once after pressing one of the programmed
dispense buttons to manually stop dispensing.
NOTE: The dispense amounts can be adjusted if required. See
"Programming The Dispenser."
NOTE: Refer to the OPTIONS AND ACCESSORIES section for
alternate, premeasure dispensing volumes.
7

OPERATION

POWER ON/OFF
(I/O) Switch
WATER
TEMPERATURE
Display
VOLUME
SELECTION
Buttons
Manual
Dispense
Button
Control Panel