Programming The Dispenser - Hatco AWD Série Manuel D'installation Et D'utilisation

OPERATION

Programming the Dispenser

WARNING
ELECTRIC SHOCK HAZARD: Turn OFF power switch,
unplug power cord, and allow unit to cool before
performing any cleaning, adjustments, or maintenance.
Dipswitch Panel
A dipswitch panel is located on the back of the control board
which is behind the front panel graphic overlay. The dip
switches have the following functions:
Dipswitch "1" is used to switch between operational mode
(RUN) and programming mode (PGm).
Dipswitch "2" is used to change the display from F° to C°.
Dipswitch "3" is used to select the type of operation and must
be switched to the AWD position for the dispenser to operate.
Dipswitch "4" is not used (can be in either position).
Changing Temperature Display from F° to C°
1. Turn the POWER ON/OFF (I/O) switch to the OFF (O)
position, and unplug the unit from the electrical receptacle.
2. Remove the two screws and slide off the top red panel.
3. move dipswitch "2" to the C position to change the display
from Fahrenheit (F°) to Celsius (C°).
4. Re-install the top red panel.
5. Plug the unit into the proper electrical receptacle and turn
the POWER ON/OFF (I/O) switch to the ON (I) position.
Changing Temperature Setpoint
1. Turn the POWER ON/OFF (I/O) switch to the OFF (O)
position and unplug the unit from the electrical receptacle.
2. Remove the two screws and slide off the top red panel.
3. move dipswitch "1" to the PGm position.
4. Place the top red panel on unit.
Never operate unit without cover installed.
5. Plug the unit into the proper electrical receptacle and turn
the POWER ON/OFF (I/O) switch to the ON (I) position.
• The display will show
indicates the beginning of the programming sequence.
• Press the red manual dispense button once and the
display will show the current temperature setpoint.
6. Use the 2QT and 3QT buttons to adjust the temperature
setpoint up or down.
7. When the desired setpoint is shown, press the red manual
dispense button to save the change to memory.
NOTE: If no buttons are pressed for a period of 15 seconds,
the program will automatically jump to the end of the
programming sequence, and the display will read END.
8. Turn the POWER ON/OFF (I/O) switch to the OFF (O)
position and unplug the unit from the electrical receptacle.
9. Remove the top red panel.
10. move dipswitch "1" back to the RUN position.
11. Re-install the top red panel using the two screws.
12. Plug the unit into the proper electrical receptacle and turn
the POWER ON/OFF (I/O) switch to the ON (I) position.
CAUTION
(temperature setpoint). This
8
English
Form No. AWDm-1016