Storage And Transport - TurMix AX 600 Mode D'emploi

5. Troubleshooting
PROBLEM
The unit does not operate
Unit does not seem to extract
enough water
The unit does not seem to be
functioning
Too loud
The unit's fan doesn't seem to
be revolving.
The continuous drainage is
not working
5. Storage and transport
Turmix-AX 600-04.indd 64
All manuals and user guides at all-guides.com
POSSIBLE CAUSES / SUGGESTED SOLUTIONS
– Is the unit plugged in? Is the mains power supply on?
– Does the water tank indicate full
– Are too many windows or doors open?
– Is there something in the room producing a lot of heat?
– Is the room cold? (the colder the air the less moisture the unit will extract). Switch on
heater.
– Is the filter dirty?
– Is the room humidity already quite low?
– Is the filter dirty?
– Is the air inlet or outlet blocked?
– Is the room humidity already quite low?
– Is the room temperature below 5 °C?
– Is the unit positioned unevenly so as to create vibration?
– Is the floor underneath the unit uneven or of unstable material?
– Is there any foreign body interfering with the unit?
– Is the filter blocked?
– Is there any foreign body interfering with the unit?
– Does the hose have a downward slope throughout its entire length?
– Is there a kink or sharp bend in the hose?
When the unit is not in use or if it is being sent to the service centre the
water tank must be emptied. On/off switch must be deactivated and the
power plug disconnected.
? Empty the water tank or reposition properly
64 64
22.1.2007 17:34:02 Uhr