SSS Siedle AFS 870-0 Mode D'emploi page 5

English
Application
Access standard handsfree tel-
ephone for the Access Professional
system, made of high-grade plastic.
Minimized ergonomically optimized
design with simple operation, clear
symbolism and excellent acoustics.
With all the key functions needed
for building communication: Calling,
speech, door release, switching/con-
trol/call barring (remote switching via
freely configurable button), muting
and storey call.
The device is an IP system product
for the PoE supply and wall
mounting with flush mounting
socket.
Electrical voltage
Mounting, installation and servicing
work on electrical devices may only
be performed by a suitably qualified
electrician.
Electrostatic charging
As a result of electrostatic charging,
direct contact with the circuit board
can result in destruction of the
device. Direct contact with the circuit
board must therefore be avoided.
Note
For use only in dry indoor atmos-
pheres.
Scope of supply
• AFS 870­... (Base plate and
housing with circuit board)
• RJ45 plug
• Operating instructions for the
end user
• This product information
Terminal assignment
1 ­ 8 LAN
ERT, ERT Storey call button
Mounting
1 Recommended mounting height
appr. 1.50 m/4.9 ft to centre device.
2 Open the device from the back
by releasing the base plate with the
locking Lever.
3 Connect the enclosed RJ45 plug-in
connector to the coupling module
installed on-site.
4 When mounting directly on the
wall, fasten the base plate using
4 screws, paying attention that
the plate is the right way up (top
marking).
5 When mounting on a switch box,
use the screw openings in the centre
of the device, paying attention that
the plate is the right way up (top
marking).
6 Install in accordance with the
wiring diagram. The cores of the
installation cable must be stored
inside the free installation space in
the base plate.
7 Connect the RJ45 plug-in con-
nector to the circuit board in the
front panel.
8 Hook the housing into the base
plate from above and close by
exerting a slight pressure.
Dismantling
9 To remove the housing, press
the lock upwards using a flat blade
screwdriver. The circuit board
remains in the housing superstruc-
ture.
Commissioning
The Access commissioning instruc-
tions and the Access planning and
system manual can be found in the
Siedle download area.
Care instructions
Only ever clean your indoor device
using a soft cloth dampened with
mild soap solution. Dry, aggres-
sive cleaning agents and abrasive
detergents can damage the surface.
Detailed care instructions are located
in the download area of
www.siedle.com.
Specifications
Operating voltage: PoE in accord-
ance with 802.3af
Ambient temperature:
+5 °C to +40 °C
Dimensions (mm) W x H x D:
79 x 133 x 23
5