Product Diagram; Lcd Touchscreen; Led Indicator Light; Setup Routine And Procedures - RCA RCU1010RF Mode D'emploi

RCU_1010_RF_IB_RevA.qxd
All manuals and user guides at all-guides.com
RCU1010RF
LEARN key
Liquid Crystal
Display (LCD)
BACKLIGHT key
Quick Access keys

LCD Touchscreen

The LCD (Liquid Crystal Display) touchscreen on your RCU1010RF acts as a "virtual keypad."
This touchscreen makes it easy to program and use your remote with many components. For the
purposes of this guide, "component" refers to your electronic equipment—TV, VCR, DVD, SAT,
PVR/DVR, CBL/AUX, CD and AUDIO equipment—all of which can be operated using the
RCU1010RF remote control unit. When you press and release a component key on the LCD
touchscreen, you put the remote in that mode (e.g., pressing the TV key puts the remote in the TV
Mode), and it remains in that mode until you press and release another mode key. When you put the
remote in a specific component mode, the control screen for that mode is shown on the touchscreen.
For example, if you put the remote in TV Mode, the control screen you see on the touchscreen
is the TV Mode control screen. Each LCD touchscreen has a maximum of 40 keys.
The LCD touchscreen remains blank when the remote is not in use. The LCD touchscreen turns
on automatically when you press and release the SETUP key, the BACKLIGHT key, or any LCD
touchscreen key. The remaining rubber keys do not activate the LCD touchscreen

LED Indicator Light

The LED (Light Emitting Diode) indicator light, located at the upper right-hand side of the
RCU1010RF unit, lights up whenever a rubber key or any LCD touchscreen key is pressed. The LED
indicator flashes and beeps three times (approximately two seconds) to indicate any error condition.

Setup Routine and Procedures

The SETUP key is located towards the lower right-hand side of the remote. The SETUP key
is used to walk you through the steps in setting up the remote. To enter the Setup Mode, press and
hold the SETUP key on the rubber keypad for 2-3 seconds until the LED indicator light remains on.
Successive presses of the SETUP key walk you through all the available Setup routines.
9/24/03 10:30 AM Page 7
LED indicator light
MACRO
Key
SETUP
key
7