Dell PowerConnect M6348 Guide De Mise En Route page 53

POST
Unit 1 - Waiting to select management unit (
)>
Applying configuration, please wait ...(
Welcome to Dell Easy Setup Wizard (
The Setup Wizard guides you through the initial switch
configuration, and gets you up and running as quickly as possible.
You can skip the setup wizard, and enter CLI mode to manually
configure the switch. You must respond to the next question to run
the setup wizard within 60 seconds, otherwise the system will
continue with normal operation using the default system
configuration.Note: You can exit the setup wizard at any point by
entering [ctrl+z]. (
60
Would you like to run the setup wizard (you must answer this
question within 60 seconds)? [Y/N] y (
] [Y/N]) y
步驟 1：
The system is not setup for SNMP management by default. To manage
the switch using SNMP (required for Dell Network Manager) you can (
Manager )
. Set up the initial SNMP version 2 account now. (
SNMP 2)
. Return later and setup other SNMP accounts. (For more
information on setting up an SNMP version 1 or 3 account,
see the user documentation). (
SNMP
Would you like to setup the SNMP management interface now? [Y/N] n
( SNMP
CLI
[ctrl+z]
SNMP
)
1 3
[Y/N]) n
1
Dell
)
SNMP (Dell Network
SNMP
...)
)
[ 60
(
))
51