Booting The Switch; Initial Configuration - Dell PowerConnect M6348 Guide De Mise En Route

3
Connect the USB type A connector on the USB cable directly to the switch USB console port.
The PowerConnect M6348 USB console port is located on the left side of the rear panel, as
shown in Figure 2.
NOTE:
If you are installing a stack of switches, connect the terminal to the Master Switch. When a stack
is powered up for the first time, the switches elect the Master Switch, which may occupy any location in
the stack. If you connect the terminal to a member switch, you will not be able to use the CLI.
Figure 2. Connecting to the Console Port

Booting the Switch

Refer to the Hardware Owner's Manual for instructions on booting the switch.

Initial Configuration

NOTE:
The initial simple configuration procedure is based on the following assumptions:
•
The PowerConnect switch was never configured before and is in the same state as when you
received it.
•
The PowerConnect switch booted successfully.
•
The console connection was established and the Dell Easy Setup Wizard prompt appears on the
screen of a VT100 terminal or terminal equivalent.
The initial switch configuration is performed through the console port. After the initial
configuration, you can manage the switch either from the already-connected console port or
remotely through an interface defined during the initial configuration.
NOTE:
The switch is not configured with a default user name and password.
NOTE:
All of the settings below are necessary to allow the remote management of the switch through
Telnet (Telnet client) or HTTP (Web browser).
console port
Getting Started Guide
9