Dell PowerConnect M6348 Guide De Mise En Route page 21

Configuring an Initial HTTPS Password
To configure an initial HTTPS password, enter the following commands:
console(config)#ip https authentication local
NOTE:
You should generate a new crypto certificate each time you upgrade (install a new version of)
the control software application on the switch.
Enter the following commands once when configuring to use an HTTPS session over a console,
a Telnet, or an SSH session.
NOTE:
In the Web browser enable SSL 2.0 or greater for the page content to appear.
console(config)#crypto certificate 1 generate
console(config)#ip https server
NOTE:
Http and Https services require level 15 access and connect directly to the configuration level
access.
Getting Started Guide
19