Step 2: Mount Nmo Outside Antenna - Wilson Electronics weBoost Drive Reach Fleet Guide D'installation

______
Step 2: Mount NMO
Outside Antenna
After hole has been drilled, insert NMO Mounting Cable
through (connector end first) and remove collar.
Position threads of the cable mount above vehicle surface.
Apply included silicone grease to the o-ring on the collar then
screw the collar to the base mount to seal opening. Ensure the
mount is centered in the hole and tighten with wrench.
remove
collar
insert through hole
For a professional installation, we recommend routing the cable
under the headliner and down through the side trim panel to
the desired booster location on the floor of the vehicle.
4
PROFESSIONAL VEHICLE SIGNAL BOOSTER KIT DRIVE REACH FLEET
apply silicone grease
apply silicone grease
screw collar
to base mount
side trim panel