Step 6: Connect Power Supply To Booster - Wilson Electronics weBoost Drive Reach Fleet Guide D'installation

______
Step 6: Connect Power
Supply To Booster
Connect the power supply cord to the end of the booster,
labeled "12V DC." Congratulations! Once your booster is
running please allow some time for your phone to adjust to
your new signal.
NOTE: Do NOT connect the power to the Signal Booster until you have
connected both the Inside and Outside Antennas.
from Inside Antenna
10
PROFESSIONAL VEHICLE SIGNAL BOOSTER KIT DRIVE REACH FLEET
Power Supply
from Outside Antenna